network Integration
cisco-dsp-modules (en)


ServicePilot network-cisco-dsp-modules


# network-cisco-dsp-modules

Overview

This package is designed to monitor Cisco DSP modules using SNMP.

Description

This package automatically configures the ServicePilot Manager to collect statistics from Cisco Voice Gateways on which SNMP service has been installed and configured.

Requirements

  • SNMP service must be installed, configured and started on the targeted Cisco Gateway (Security: read-only SNMP community and allowed host must be set).

  • Network Flows - It is necessary to ensure network connectivity between ServicePilot and the monitored device. In case of a network infrastructure with a firewall, all of the following flows must be opened:

    • UDP/161 (SNMP): Between ServicePilot Manager and Cisco Gateway
  • ServicePilot Requirements

    • ServicePilot Manager minimum version: 8.5

Installation

Before adding a resource to monitor, make certain that all pre-requisites are in place and if a ServicePilot Agent is required, that it is communicating correctly with the ServicePilot Manager.

Add resource using Views Configuration web interface

  1. As an administrative user of ServicePilot, open the ServicePilot web interface.
  2. Navigate to Administration. The Configuration > Views web page will open.
  3. Click on the view in which to place the new resource in the Views hierarchy on the left of the interface. The View editor section will show the existing view contents.
  4. From the Packages list on the right of the interface, click and drag the network-cisco-dsp-modules package into the View editor and let go.
  5. The Resource properties dialog box will open to allow resource configuration.
  6. Click OK to close the Resource properties dialog box. Note that the dialog box will not close if required parameters are not set.
  7. Click Save to apply the new resource to ServicePilot configuration.

Key field notes

In the Monitoring Policies tab, specify the policy or policies to apply to the resource

  1. Basic Parameters tab:
    1. IP address: Specify the IP address of the Cisco device through which the DSP modules are visible using SNMP

Notes

MIBs Used:

  • CISCO-DSP-MGMT-MIB

Nous pouvons vous aider

ou appelez-nous au +33 2 40 60 13 30